Page 2 - Raritan Hold-N-Treat Electroscan EST System L372v0717
P. 2

OPERATION


              Important
             •  Ensure the Electro Scan is operating properly.
                Refer to the Electro Scan Manual for proper opera-
                tion.
             •  Use of certain chemicals in toilet or holding tank
                will cause damage to the Electro Scan. We rec-
                ommend ONLY Raritan C.P. Cleans Potties and          RED
                Raritan K.O. Kills Odors.                                                         GREEN
             •  Select "NO DISCHARGE" mode to prevent acti-
                vation of the ‘Hold n’ Treat when in No Discharge   Flashing:           Flashing:
                Zones.                                           Warning: See display   Treatment process on
                                                                 Solid:
             TO SET MODE:                                        Error: See display
              There is a 5 second delay for changed mode to be
                 effective. Mode can only be set when unit is
                 not  in a cycle.
             Scroll to "MODE" screen using ">" key.
             Use MODE key to toggle between AUTOMATIC,                             AUTOMATIC
                 MANUAL or NO DISCHARGE mode.                                    PRS MODE TO CHG
             Use "<" key to return to home screen or control will
                 reurn to home screen after few seconds.
             Note : Default mode after powering up is mode
                 in which unit was last run. In case of loss of
                 power unit will go to back to mode it was run-   PRESS  TO                 PRESS TO SWITCH
                 ning. Units are shipped with nodischarge mode   TOGGLE BETWEEN MODE        TO THIS SCREEN


              DISPLAY STATUS

              AUTOMATIC  MODE:                                                   ****STANDBY****   ****STANDBY****
              Treatment starts when  level is higher than the low level         MODE AUTOMATICMODE AUTOMATIC
                in the tank and continues till level is lower than low
                level. Display indicates one of the following status
             •  Pretreatment or treatment cycle
                         Electroscan treatment cycle is running, see
                electroscan manual for details on display
             •  Processing: between cycles

                         Treatment is between cycles, there is a 30
                second wait before next cycle starts. Green LED will                PROCESSING
                                                                                 BETWEEN CYCLE
                flash on system status panel during this time
             •  Processing: cooldown cycle
                         Treatment has processed five cycle and
                system is in cooldown cycle for 15 minutes. System
                status green LED will flash during this time.

             •  Standby mode: tank is near empty
             NOTE: If start/stop button is pressed to stop electroscan
                treatment cycle , mode will change to MANUAL.                         PROCESSING
                                                                                COOLDOWN CYCLE







                                                              2                                       L372 0717jlc
                                                              2
   1   2   3   4   5   6   7