Page 4 - Raritan Icerette Owners Manual- 550v0216v

SAFETY • Make certain that hoses are not pinched, kinked or damaged during installation.

•
Check for leaks after water line is connected.
•
Although the unit has been tested and cleaned at the factory, due to long-term transit and
storage, the first batch of cubes must be discarded.

•
Remove the packing materials and clean the ice maker before using.
Turn on the water supply tap before switching on the ice maker. Never turn the water
•
Except to take ice from the unit, keep the door closed in order to reduce ice melting and
• supply tap off when the ice maker is working.
to promote proper ice formation.
• If the ice maker will not be used for a long time, before the next use it must be thoroughly
cleaned. Follow carefully any instructions provided for cleaning or use of sanitizing
solution. Do not leave any solution inside the ice maker after cleaning.
• Do not touch the condenser fins. They are sharp and can be easily damaged.
• Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners
may transmit taste to the ice cubes, or damage or discolor the interior.
• Do not use the apparatus other than for its intended purpose.
• Cleaning and user maintenance shall not be made by children without supervision.

SAVE THESE INSTRUCTIONS

Electrical Connection
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded. The power cord of this appliance is
equipped with a 3-prong grounding plug that mates with a standard 3-prong grounding wall outlet to
minimize the possibility of electric shock hazard from the appliance. Have the wall outlet and circuit
checked by a qualified electrician to make sure the outlet is properly grounded. When a standard
2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a
properly grounded 3-prong wall outlet.

The ice maker should always be plugged into its own individual electrical outlet which has a voltage
rating that matches the rating label on the appliance. This provides the best performance and also
prevents overloading boat wiring circuits which could cause a fire hazard from overheated wires.
Never unplug your ice maker by pulling on the power cord. Always grip the plug firmly and pull
straight out from the outlet. Repair or replace immediately all power cords that have become frayed
or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at
either end. When moving the ice maker, be careful not to damage the power cord.

If the supply card is damaged, it must be replaced by the manufacture, its service agent or similarly
qualified persons in order to avoid a hazard.

Extension Cord
Because of potential safety hazards under certain conditions, it is strongly recommended that you do
not use an extension cord with this ice maker. SAVE THESE INSTRUCTIONS SAVE THESE,

L550vkm0216 4